FOR USE WITH COUNTER-CLOCKWISE TURNING TRIMMERS ONLY!!
WARNING! Read and understand operators manual before using BRUSH DAWG®. Failure to follow operating instructions could result in death or serious injury.
- To refill the line, make sure trimmer is off, turn the bump spool (bottom of BRUSH DAWG®) in the direction of the arrow in the counter clockwise position, you should feel it release, remove on the bump spool. Take approximately 20’ of line, find the middle, by putting the two ends together and sliding your hand toward the middle of both lines, while holding them together. When you find the middle add 4-5” to one side, so the line is longer on one end. Take the middle of the line and put it in the slot on the middle divider of the spool, then wrap in a counter clockwise rotation or the direction of the arrow, with one line on each side of the divider, until all the line is in the spool. You should have about 6” of line coming away from the spool, the line that was longer will get wrapped another half of spool so it will be equal in length. Use the slots in the outer edge of the spool to hold the line. Line up the two little buttons on the indexing barrel on the inside of the BRUSH DAWG® head toward the two eyelets, (you may have to push down and turn the barrel) then take each line and insert it from the inside of the head to the outside. Then grab both lines and pull tight quickly. Make sure the bump spool locks into place. Start trimmer, and bump to test operation.
- Inspect blade occasionally, do not use if blade is bent or damaged, this may cause and imbalance in the head and damage your trimmer.
- It may be necessary to sharpen blades occasionally. Always take it to a professional sharpening service for this.
- BRUSH DAWG® head may be used with or without the metal blade.
- Replacement parts may be purchased online at BrushDawg.com